Wolseley Spares

Wolseley Hornet Special.

Over size oil pump gears in stock, two types.


All fitted to Your body and machined to  re-establish fit in pump as New.


Prices for complete overhaul:

Early Type  £225.00 ex-works.

12 hp Type   £250.00 ex-works.

14 long gear £275.00 ex-works.

New 14 Type £275.00 ex-works

9hp threaded  £275.00 ex-works.

    

Skew gear sets.  For early and late engines. Sold as sets only.

EN40B Nitrided.


Early set   £450.00 ex-works

Later pair £370.00 ex-works

New 14hp £350.00 ex-works



Distributor drive gears late engine.

EN40B Nitrided.


£100.00 ex-works

Heard stories of New timing gears having to be made of Bronze as Steel do not last five minutes.


These are ours after 2,500 miles of hard racing level use in a blown 12hp crossflow 100BHP engine giving 100psi oil pressure on one of our reconditioned pumps.

Not to Self : need to open out dump hole or not make such a good job of overhaul on pumps.


Moral of story;  Make  gears from EN40b and nitride correctly, build engine making sure mesh is correct. (Crank position critical.)


Serving Suggestion!


Note: water pump drive in this engine was not correct year, thus later drive gear needed.

Some of the Engines built by Brooklands Enginecraft.

Coming soon, L/W flywheels and clutches for Pre Crossflow engines & 14hp.

  New steel rods for shells.

Parts for 12hp and 14hp Pre War Wolseley Hornet 6 Cylinder Engines.


We have taken it on ourselves to Produce a few Wolseley Hornet parts to our normal High standard, to be sure of what we are fitting into the engines we build.

This has allowed us to now offer  these to any Wolseley Hornet owner.

 


Sprockets For Hornet Special engines.

Single and Duplex crank shaft type and early 12hp. New 12 and 14

All types will be supplied in time.

EN24T is used for long life.


New Hardened tensioner gears for early 12hp, refurb of your hub is included and new gear ground to suit. All sprockets available for these early engines.


Idler gear standard or modified to use 2 needle roller bearings, mod to shaft included in prices.

P.O.A.

Wolseley & MG J2 & PB Gearbox gears.

New 1st and 2nd straight cut gears for the 1933 crash boxes

Including fitting of New parts to your shafts and gears in price.

Other boxes now covered see bottom of page.


£1,000.00 ex-works.

New Product : Early 12hp rockershafts.

Sold in pairs only.

£100.00 ex-works

Totally New Starter Motor.

Higher power than the original ones.


£300.00 plus postage.


WHS Speedometer drive gears, driven only. 12 teeth to mesh with 7 start worm gear.

EN40B Nitrided.


£75.00 ex-works.


MG & Wolseley gearbox input shaft reclamation. 

Welded with a hard steel, then ground back to fit.


POA 


Wolseley Water Pumps, Reconditioned on receipt at works.


New modern ceramic water pump seal fitted, with new bush and drive shaft.


No cosmetic work included in price.  No repairs to castings. No exchange as so many pumps are damaged.

 

£125.00 ex-works            Sand blast and primed at extra cost.

Pre War Wolseley speedo gears.

EN40b Nitrided 3 start worm 12 teeth driven gear.


£150.00 per pair plus postage.


Lucas E35 dynamo 12 volt.  Converted to Two brush and overhauld.


£175.00 plus postage.

Wolseley 12/32 Four Cylinder Car. Hand book workshop Manual. 82 pages, not best condition, but readable  


£20.00 plus post.

Startix parts   please ask for details

I have some used early Pre cross flow parts for sale also, please ask with you needs.

Early Hornet 31-33 Light Weight flywheel. Comes in at 5.7Kgs   The original one shown, already turned down in size is 11.6Kgs.  Can work with original clutch, or Ford Diaphragm Type.  Please state which when ordering.    £595.00 plus post.

14hp Light Wieght Flywheel. 


$475.00 plus postage.


New 14hp rear main bearing housings & engine plates for either gearbox type.  Please contact for details.

New item.   Wolseley & MG J2 remote gear change lever.

8" overall. 

Made from EN24 in the T condition and then fully hadened and tampered on small ball end.


£125.00 plus postage



Early 12hp eccentric sprocket hub.  Send us your old sprocket and we will grind the bore back to round and parallel.  Then we grind the New eccentric to be correct fit into bore. 

Remove all that wobble and ware.


£125.00 ex work

New Replacement gears for Synchro and Early crash boxes. Case hardened EN36, ground to suit your herringbone  gears, if sent to us (recommended)   As with early set, bores had become worn and gear was loose.  New shaft made to work correctly, and on any original gears they we selectively assembled as tolerances were not highly accurate.


Early set have extra tooth on second gear, making them the same as the 33 box. Both sets come with New double sliding gear for output shaft.

 

£1,000.00 plus shipping.

1932 Engine and gearbox complete.

As found engine, with rebuilt gearbox.


Comes with starter, Dynamo and carb.


Ask for deatails.

Pair of WHS 1 1/8” SU carburettors.   

Fully rebuilt and ready to fit.


Can have manifolds at extra cost.

 

£800.00 ex works.

For Sale. a New pair of 1 1/8" SU carburettors. Built by Burlen Services, not used and now surplus to requirements. Made for WHS.


New cost( if you can even get them made) £1,800+ These are £1,400.00 the pair ready to fit a car. 

Plus Shipping

New oil pump bodies arrived to make deeper geared pumps as 14hp. These will be 0.750" long in place of the 0.562"standard 12hp. The intention is to supply matched to the old pump parts. But could also be made completely new if they have to be.


Price to be set once first ones fully machined. Also possible water pump support upgrade for New 14 engine of if you have the 9hp pump fitted now, to make more like the 34 12hp drive system. Also same type of support for 12hp when no water pump is driven.


Have made New 14hp standard cross gears if water pump drive in needed.

All styles of cross gear back in stock, sold in sets only.